Is this the screw you are referring to? If so then that's the screw I am referring to above. The problem seems to be there is up and down play in the safety bar. If I adjust the screw to just touch the safety bar the gun will still fire because the safety bar will move upward. If I adjust the screw to remove the play, while on safe, the safety bar drops off of the screw when the safety is off and then it won't return to safe because the screw is in the way. I've adjusted this on the non-Accutrigger and realize you don't have to turn the screw much but I'm talking a minuscule amount here. The picture shown is not my trigger. The one shown is a stock Accutrigger. I'm not able to us the little spring that runs through the trigger housing as that hole is halfway blocked by the non-Accutrigger safety bar. If I was able to get that little spring in then it may hold the safety bar upward slightly and remove the play I'm talking about?