Welcome on! And, I believe you mean Center feed magazine? Yes, it can work. It’s been discussed & several have accomplished this. However, some machining is required to the back of the magazine well(of the Action). Looking at your Stevens Action, compare the mag outlet to this photo below. It needs to be machined slightly rounded(the side Closest to the Trigger which I call the “back” of the Action.) It can & has been done by people depending on your motivation know how. However, I would not touch a thing until you have all parts to constantly test fit. You only want to remove the least material possible to fit the magazine correctly. Also. Some may caution doing a RUM cartridge in a Small Shank Action. Even finding a Prefit Barrel in RUM can prove to be difficult. WinMag is OK though.
Staggerfeed to Centerfeed machining modification.
Besides the bit of machining, you will need the other normal parts associated with any build: the Barrel in your chosen cartridge, a new Recoil Lug & Barrel Nut are recommended. And of course, the correct size Bolt Head.
Bookmarks