Where to buy bolt parts?

[USMarine1108]

I'm in need of a bolt part. I'm not sure of the exact name, but what I need is the small gear looking washer that the spring sets against on the aft (handle side) of the spring. The small lugs from the cocking piece sleeve lock into this small gear/washer. Where can I get this thing from?

[thirty06]

Buddy broke the same piece. He ended up buying a firing pin assembly from Midway.It was less than $20.00 if I remember right.

[dmack]

I think you're talking about the Cocking piece lock washer.

Brownells:

http://www.brownells.com/.aspx/sid=3...000249_d_10956

[jglover_81]

Buddy broke the same piece. He ended up buying a firing pin assembly from Midway.It was less than $20.00 if I remember right.

Yep I sure did ::) If you have a short action try this...
http://www.midwayusa.com/viewProduct...tNumber=865680

for a long action try this...
http://www.midwayusa.com/viewProduct...tNumber=630992

[USMarine1108]

Wow, thanks guys. I think I'll just buy the whole thing for $13 more and have some spare parts. So that one will work for a 110 30-06? What's the difference between the "small version" and "large version"?

[Nor Cal Mikie]

Midway is getting "kinda strange". Last I heard you have to have an FFL to get bolt head and related parts? Check it out and if so, be ready to jump through hoops. Sinclair might be a better choice.

[jglover_81]

The older firing pins are large... all the new ones are small diameter

I have recently bought bolt parts from midway without any question of an FFl

[Nor Cal Mikie]

I had heard a few months ago that the FFL was required. Never had any problems myself so I wasn't sure.

[USMarine1108]

Is there any way to tell if I have large or small? Anyone know dimentions so I can mic it?

[thirty06]

If you measure your firing pin at the spot that goes through the retaining pin it should be
.145= large pin
.095=small pin
There's more info at top of page in the FAQ section.

[USMarine1108]

Awesome. Thanks guys.