Reply With QuoteNice job. What are the drawings under the stock? Blueprint of where to put the pillar?
I thought I d post my 3rd screw modification on the BC MED stock. It works fine with two , but I just went ahead and glassed a stainless pillar for the center screw. Seems to work fine. The pillar is left over barrel from when I cut my Marlin 22 MicroGroove off :)
Anyways here's the pics.
[img width=600 height=395]http://i198.photobucket.com/albums/aa37/snapshot12002/3rdpillar1.jpg[/img]
[img width=600 height=443]http://i198.photobucket.com/albums/aa37/snapshot12002/3rdpillar2.jpg[/img]
Nice job. What are the drawings under the stock? Blueprint of where to put the pillar?
112,223,choate uv,nikon 6-18<br />lrpv,204,hs stock,sightron S3 6-24x50<br />12 target,McGowen 6mmbr,SSS hbr,Sightron S3 8-32<br />Mark II,22lr,thumbhole,Tasco 6-24x40<br />11 youth,243,Simmons 2.5-10x50<br />116fcss 30-06<br />12fv,204,VX-3 4.5-14x50
Those are blueprints that came with the target action.
To free float the barrel in this stock. Its a straight taper to 1 inch. I used a 22mm deep impact socket wrapped in 60 grit sandpaper and worked on it for about an hour to open up and deepen the stock so it would not touch.
I drilled 1/8 inch holes in the stock about a 1/16 inch deep to know how much material I was removing.
Conrad
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks