I just use a couple of washers, seems to work fine for me.
OK, bought a B&C medalist tactical SA(of course) and a metal trigger guard to use with it.....the trigger guard of original design(Stevens 200) is plastic, and thicker in the front....is there a easy and neat way to bring the metal housing up to the proper height? I can use use Devcon, just wondering if there is a more common method? Thanks, rsbhunter
If you stand for nothing, Then you'll fall for anything!
I just use a couple of washers, seems to work fine for me.
me too
bob
Me three...
Just find small flat-washers that are about as big around as the pillar. Stack them up till the trigger guard sits as close to flush as you can get it. Then I take those washers and silicone or epoxy them together to form 1 bigger spacer(so it is harder to lose at a later date...LOL).
”I have a very strict gun control policy: if there’s a gun around, I want to be in control of it.”
~Clint Eastwood
I like to use epoxy and bed it to bring it up, but either way will work fine.
One washer and marine-tex works for me.
Bookmarks