looks like the long side goes out
assembing a new bolt, down to installing the plunger ejector.
the groove cut for the retaining pin in it is offset - one side is short, the other is long.
which end goes in? The FAQ doesn't say.
looks like the long side goes out
That is the way mine was when I took it out of my benchgun. The long side should a little rounded the way I am told.
The short side in. Although I haven't tried I doubt you'll be able to install the cross pin if its in backwards.Originally Posted by Rob Rat
Bill
Originally Posted by BillPa
The ejector will go in backwards, at least on my .378 bolt head they will. I do this so I don't have to hunt down my brass. I know if I take it out I will loose the little pins and spring. Makes for a great place to store them. The rouned edge goes out and the flat side goes against the sprint.
Dolomite
Bookmarks