Push the cross pin out that holds the trigger bracket and sear. Just keep a finger or something over the sear spring as they have a nasty habit of flying off into infinity.
Re-assembly can be a bit tricky but nothing terrible.
Have model 12 with accutrigger. Was bought used and was spray painted. Want to redo, plus do a bedding job. Can complete trigger assembly be removed
without taking apart in pieces? If so, how does one go about doing this?
Greg
Push the cross pin out that holds the trigger bracket and sear. Just keep a finger or something over the sear spring as they have a nasty habit of flying off into infinity.
Re-assembly can be a bit tricky but nothing terrible.
Thanks Trappst. I had read something like that here before , was'nt quite sure . Thanks for quick reply.
Greg
Another tip would to get yourself a small punch the same diameter or less than the cross pin to use as a slave. Insert it first through the trigger housing and then follow it back out with the cross pin. This will help in keeping things in alignment.
Bookmarks