Reply With QuoteThat's the nature of the beast when using factory take off barrels. You just have to deal with it. That's probably one of the reasons why after market barrels don't use roll marks like that.
Need some thoughts.
I am currently swapping a Stevens 200 .270 into a factory 25-06 barrel. First time doing this type of swap, but do have all the necessary equipment and youtube. My problem is that on the first go, the roll marks do not even come close to where they should be. I was under the impression since it was for a factory to factory barrel swap, they would line up close. As it is, the caliber roll mark ends up directly down.
Anyone have any suggestions? I think my OCD will drive me crazy if the address stays at the bottom
Thanks for any suggestions,
Kansan
That's the nature of the beast when using factory take off barrels. You just have to deal with it. That's probably one of the reasons why after market barrels don't use roll marks like that.
One note, I did not remove the ejector from the bolt while setting headspace. Does anyone this this makes a difference?
Kansan
Nope.Originally Posted by Kansan
I may line up the roll marks to my liking and get a finish reamer. Larry Potterfield makes it looks so easy on Youtube :)
Kansan
Last edited by Kansan; 01-25-2014 at 02:27 PM.
Kind of defeats the purpose of the barrel nut, no ? You may run into a problem with the front of the bolt lugs bottoming out on the barrel. you may have to machine off the back of the barrel the same amount as you reamed to keep things copacetic.
Last edited by RP12; 01-25-2014 at 07:02 PM.
My 110 in 204 Ruger is like that. Factory take off barrel from a Model 12. Roll marks are way off.
The important thing is that the headspacing is right.
Yeah, the bolt would bottom out on the barrel. I'm just going to restamp the barrel.
Thanks for the input.
Kansan
If it really bothers you the best way to do it is have the barrel shaved and the chamber recut to get it to line up properly. It shouldn't cost very much to do.
.
Don't you believe that having the current caliber or cartridge on the barrel defeats most of the fun of a swap barrel gun ?
.
Posting Permissions
Bookmarks