Reply With Quotenope... you are bedding that action/recoil lug to that stock. The barrel dont matter, and it should all go back in the same place whenever you take it apart.
I have not bedded my 110 into the duramax stock because it is only temporary until the LVT gets here from SSS. Once I get it bedded into the LVT will I have to rebed every time I change barrels? When you take the action out to change barrels do you " mess up " the bedding job?
nope... you are bedding that action/recoil lug to that stock. The barrel dont matter, and it should all go back in the same place whenever you take it apart.
”I have a very strict gun control policy: if there’s a gun around, I want to be in control of it.”
~Clint Eastwood
Ok thanks- I was not sure if the bedding material bonded to the action or not. I guess once it hardens and you remove the action it goes right back into the imprint.
If you don't use release agent, it will bond to the receiver and you will have a big problem. Your bedding kit will come with release agent, but I usually use Johnson paste wax on anything I don't want bonded.
Pam cooking spray works really good too.
Best thing to do is to read the bedding how-to article on the main page before you attempt it, cause you also have to remove the trigger and fill in all the little holes and indentations in the action with modeling clay(or play-doh).
http://savageshooters.com/index.php?...0Bedding%20101
”I have a very strict gun control policy: if there’s a gun around, I want to be in control of it.”
~Clint Eastwood
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks