I recently purchased a Savage 93 17HMR. Took it to the gun club, sighted it in, took it home cleaned it. I pulled the bolt out by removing the clip, knocking it off safety, held the trigger in and when I slide it back, the front part of the bolt slide back with it, then stopped and the blued back part of the bolt came on out, leaving the front part partially in. I carefully slide it on out and slide it back into the main rear part of the bolt. This was done by lining it up, slide it on and turned it in the correct position and put it all back togeather. I have never had this to happen with any of my other bolt actions. Thought it was odd, but it works fine after putting it back in. While it was out I examined it and slide it off and back on several times. I have not shot it yet and I hope this is normal. It just seems like something should be holding the two togeather. All I have to do is turn it and slide it off the rear or main part of the bolt to take it apart. Any suggestions?
Thanks