Reply With Quotenope, not safely anyways, and I don't think it should even chamber. You can shoot .223 in a 5.56 chamber, but you can't (shouldn't be able to) shoot 5.56 in a .223 chamber.
Did a search and found nothing. Anyone know for sure? Thanks
nope, not safely anyways, and I don't think it should even chamber. You can shoot .223 in a 5.56 chamber, but you can't (shouldn't be able to) shoot 5.56 in a .223 chamber.
It will certainly chamber and while it is a "no no" to fire 5.56 ammo in a 223 chamber and will likely get over standard pressure, it will generally not cause a "dangerous" situation in a modern, strong bolt action.
Of course if your 223 chamber has a long throat it may not be an issue at all.
You will see problems in semi autos and break open single shots etc.
Of course I would never say it is "ok" and your mileage may vary etc. etc.
Not the kind of ammo to see what your Edge will do anyway - not very accurate and steel core ammo isn't the best for your barrel.
There is no difference in actual chamber pressures between the two cartridges and the European CIP the equivalent of the American SAAMI rates the pressures as being equal. The real diffrence is the throat or leade in their chambering
"NATO chambers have a long leade, SAAMI chambers are tighter and have a short leade. SAAMI chambers are designed for increased accuracy, but will yield dangerously high pressures in guns using military ammunition and/or which are subject to high volume shooting.
[img width=461 height=450]http://i122.photobucket.com/albums/o254/bigedp51/556natochamberversus223remingtonchamber02.jpg[/img]
On top of this as an example below you have five different chamber configurations.
[img width=583 height=450]http://i122.photobucket.com/albums/o254/bigedp51/223reamers-1.jpg[/img]
Contact Savage and find out which reamer is used and if the throat is standard SAAMI or a variant. Savage has 1 in 9 twist barrels that are made for longer and heavier bullets and "might" have longer throats vs the 1 in 12-14 twist barrels.
I was told by a ??? not too reliable source that all the Savage .223's are cut to handle 5.56's. I will give them a call.
I hope you do call and then post the response from Savage. I would really like a definitive answer to this question. I imagine that there are others in the same boat.
Out
West
Talk to Savage yesterday and was told that they Edge .223 are NOT cut to handle a 5.56 round. Said some other models are but the Edge is not.
Did they say which models 5.56 would work in? Am currently interested in a .223 tactical and would like to purchase one that can fire 5.56 as well.Originally Posted by jrbdad
I'm also intersted in a Savage that can fire 223 and 556. But, I wonder if cutting it for 556 would hurt the accuracy with 223. Anybody know?
Wonder why Savage would cut .223 barrels differently depending on what model the barrel was going on?
I would guess their 1:9 and 1:7 twist barrels can shoot 5.56 just fine. If they are making them with that kinda twist then you would think they were throated for heavier bullets.
More shooting, less typing.
I went to the Savage parts finder page. Here's what I found. It looks like the 12FV will shoot the 5.56 too. Search: Search Welcome
My AccountMy WishlistMy CartCheckoutLog In...Store HomeApparel
Gear
Magazines/Misc. Parts
Part FinderSavage Arms.Home » Part Finder
To begin, enter your firearm's serial number:
Launch Part Finder
MOD 12FV 223 REM
Model Specific PartsParts/Accessories not shown on schematicShopping Cart Preview
BBL 223-5.56 TARGET/26 VR
This is either a factory fit only component or this component is restricted to gunsmiths. TENSION ADJ TOOL (ACCU-TRIG)$2.00 Qty: Add to Cart .
Schematics are for reference only. Savage Arms strongly recommends that any work performed on a firearm be done by a qualified gunsmith. The consumer assumes all responsibility/liability for any damages or injuries resulting from work performed. ..Returns | Contact Savage
Site MapSearch TermsAdvanced Search
Savage Arms Store. All Rights Reserved
I have heard mention of the 223wylde, what is this variation? I glean it was some sort of 223/556 compromise chamber, but I have not been able to confirm this.
Whenever the legislators endeavor to take away and destroy the property of the people, or to reduce them to slavery under arbitrary power, they put themselves into a state of war with the people, who are thereupon absolved from any further obedience
The Wylde is considered a semi match chamber with a modified throat so that 5.56 can be used. The Wylde is common in ARs where a shooter may want the ability to switch between .223 ammo for targets/varmints and then shoot 5.56 for plinking or defense situations.
very interesting... 8)
Whenever the legislators endeavor to take away and destroy the property of the people, or to reduce them to slavery under arbitrary power, they put themselves into a state of war with the people, who are thereupon absolved from any further obedience
yep there is a difference between C.O.L, the 5.56 is slightly longer so it will cause throat wear. a slightly set back shoulder. also the 5.56 has higher pressure. i loaded half of my 30 rd mag with federal 223 and the other half with federal 5.56 the nato round is pretty hot compared to the 223 louder report and more recoil. i always been told if you have one stamped on the barrel 223 thats all you shoot is 223, if its marked 5.56 you can shoot nato rounds or 223. i am so glad i opted for the 5.56 chamber in my colt ar, because the federal nato ammo is cheap.
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks