I haven't done it on an HS, but I have on cheaper stocks, no issues. . . Don't worry about it, just use a good bit and you should be fine.
I am thinking about putting a Karsten cheekpiece on my Savage 10FCP HS Precision, but honestly I'm a little nervous. How strong is this stock? It's not going to crack or anything when I drill the holes, right? And also, if anyone has done this on this stock, is the butt area hollow? Thanks in advance
I haven't done it on an HS, but I have on cheaper stocks, no issues. . . Don't worry about it, just use a good bit and you should be fine.
Romans 10:9 "That if you confess with your mouth, Jesus is Lord, and believe in your heart that God raised him from the dead, you will be saved."
I wouldn't have a problem doing it on a normal plastic synthetic stock, but I'm wondering if anyone has done it on a fiberglass stock like the HS Prec.
I did it on a Duramaxx, it's fiberglass. . .
Romans 10:9 "That if you confess with your mouth, Jesus is Lord, and believe in your heart that God raised him from the dead, you will be saved."
Sorry, I didn't know that's what you meant by synthetic. I didn't mean that disrespectfully. Thanks for the advice, I'll just buy a new drill bit to be sure :) I would hate to mess up that stock Thanks again
No disrepect, I wasn't clear!
I would suggest masking taping the stock where you will drill though, should help minimize chipping around the hole.
Yeah, HS is worth being cautious with, I agree!
Adam
Romans 10:9 "That if you confess with your mouth, Jesus is Lord, and believe in your heart that God raised him from the dead, you will be saved."
Bookmarks