Savage 110 ultralite bottom metal washers

[Rifle20]

I finally got my 110 ultralite 6.5 creedmoor back from Savage feeds better but still not 100 precent. The issue I have now is I took the bottom metal off and removed the stock. In the process I had two metal washer/inserts fall out. I am trying to figure out where they go in the magazine well and trigger guard? I am thing they go on top of the magazine well so you have metal to metal contact with pillars. Any help will be greatly appreciated.

[J.Baker]

I'm guessing your assumption is likely right as that one of only two places they could go. The other would be between the action and the stock, but that wouldn't make much sense and they would likely end up curved to match the curvature of the action if in that location.

Only other possible location would just be for the rear one which would be between the magazine housing and the trigger guard.

Just have to do aa little trial and error to see what looks/fits right.

[pdog06]

Pictures would help us give a more confident answer

[Rifle20]

I finally got my 110 ultralite 6.5 creedmoor back from Savage feeds better but still not 100 precent. The issue I have now is I took the bottom metal off and removed the stock. In the process I had two metal washer/inserts fall out. I am trying to figure out where they go in the magazine well and trigger guard? I am thing they go on top of the magazine well so you have metal to metal contact with pillars. Any help will be greatly appreciated.