So, I bought an Oryx chassis and since mounting my action in it, I never could get it to settle down.

I placed a disc of clay on the back post area of the stock and torqued the front action bolt to 35 in lb and the rear post is not making contact with the chassis.

I measured the chassis and the rear mount area is .053" lower than the front mount area.

When I measured the clay impression of the rear mount it was more than .053", so I assume either the front post is not parallel or the pressure of the clay held it off a small amount.

I assume both of the action posts are supposed to be parallel and the same length. At least eyeballing it all three posts seem to line up.

I also clayed the rear post behind the trigger to make sure it is not hitting, and it is not.

Besides bedding the stock, what do you guys think I should do?

It seems like bedding is my only option other than returning the stock.
According to the adverts the Oryx chassis should not need to be bedded.

Does anybody have a dimensioned drawing of a Savage MkII with the accutrigger?

Thanks