Bolt AR what a hoot.

[NF1E]

Had some time this morning waiting for the range grass to dry before mowing. Found a few old boxes of 77 gn GMM laying on the shelf and just needed shooting up as it has been replaced with a couple of cases of 73 gn Berger GMM. Dang I love the smell of gunsmoke in the morning. Shot off bipod. Before using the GMM up, I shot 20 rnds of hand loaded 40 gn Vmax to warm things up. Did have to add the suppressor cover to cut down the mirage which was terrible after the first 30 rnds. I do enjoy using the NRA MR-31C targets which are 600 yd scaled down for 100 yds with a 3/4" X ring. Whatta Hobby!

[Dave Hoback]

That’ll do it.

[NF1E]

Thanks. With the Lyme, I need all the range time I can get just to stay focused.

[NF1E]

Well, got out an fired just 20 rnds with my bolt AR. Trying new ammo. I bought a couple of cases of Federal GM .223 that uses Berger 73 gn otm which is advertised as 2800 fps at the muzzle. Left the scope with setting from handloads that were running the same. First 2 shots clean cold bore were dead center on my sight in target then creeped up slightly. Dropped the elevation 2 clicks and moved onto an MR-31 and shot a 100-9x. First two shots on the MR-31C were at 11 oclock. Left the scope setting alone because they were Xs and the rest were down near 6, go figure. One thing I noticed with this ammo is it produces tons of white smoke. Almost like shooting black powder. I like the 7 rnds through the one 1/4" hole at 6. Now if I could get over being exhausted it would be a lot more fun. Whatta Hobby!

[NF1E]

Fired 20 rnds at 100 yds this morning with my bolt AR Unitah 20" upper .223 Wylde. I think 9th is going to like his when he gets a chance to shoot it. Amazing!

Warmup on sightin target produced 5/8" max spread for 10 rnds. Moved the scope up one click and left one click before shooting the MR-31C. Final score is 100-10X. 1/2" max spread for 10 rnds. This is shot off Atlas bipod with bunny bag. Next goal with this rifle is to shoot a 100-10X without breaking the X ring. Whatta Hobby!

[Dave Hoback]

Yessir… AR’s can definitely get the job done! I had thought on one of those Unitah Uppers, but I’m quite fond of my Semi-Auto AR15’s. (And truth of the matter is I build my own better than any manufacturer I’ve seen in 2 decades of building them.) Then I always just figured, I can shot off the port on the Adjustable Gas Block I use & run mine like a straight pull.

But that’s one straight shooting rig you got there.