Finally got my new Hunter in .223
First the Cons:
Magazine got stuck and I had to take the rifle apart to get it out. Rear mag latch lip was a scooch to long, had to file it down about .020 now it fits into the magwell perfect and removes perfect. Chamber long throated, if I load 55 Vmax's at book spec of 2.250 they will have a jump of .100. Luckily there is room in the mag to load bullets long.
Next, trigger was #3.75, will not go lower than #2.80, will have to see if there are any springs I can change to get it to about #2.25
Bolt release is a bit stiff and gritty.
Rubbing the exterior of the barrel down with oil
I got a lot of black covered patches.
Follower sets to low to properly single feed with some bullet types.
#9, 4oz with scope

Now the good stuff:

I think the best thing is the Accufit AccuStock.
Comes with 5 cheek risers, I chose the middle size and I think it is about perfect.
The aluminum bedding block and inside of stock is smooth and clean, very well done.
I torqued the stock to spec at #40 inch pounds.
Barrel is free floated perfectly and even all the way down.
Mounted a EGW O MOA Rail and Vortex Diamondback Tactical 4-16x44 FFP in
Leupold 30mm QRW2 medium rings.
So far very pleased, but a range trip will be the overall deciding factor.
Range day planned for Sunday morning, so stay tuned.