Anybody got any recommendations for a bore guide? Bunch of them out there. Thanks in advance for any input.
Anybody got any recommendations for a bore guide? Bunch of them out there. Thanks in advance for any input.
There are a lot of good options, but for a cheap but effective one look at Possum Hollow bore guides.
Why do folks us a bore guide on rifles bolt actions.
Honest question.
Sent from my iPhone using Tapatalk
I always push from chamber to muzzle and take the patch or brush off before pulling it back. Makes since though. Especially if you had a nice finish wood stock.
Sent from my iPhone using Tapatalk
Bought a cheap one when Gander Mountain was going out of business.
Did'nt take long to figure something was wrong. Patch's were getting
darker then normal. Turns out the solvents were eating the plastic. Chinese
junk, so beware on the cheap ones. I bought a length of nylon rod and
turned one specific for the PTA's. I also made one from copper tubing, and
soldered to a rifle case, I had cut the head off. Good for general cleaning, but
do not use it when copper solvents are needed.
Keeping my bad Karma intact since 1952
+1 Possum Hollow
+2 Possum Hollow
Use a bore guide. Use a proper fitted patch. Clean the gun. Rod material does not really matter. Do use a single piece rod that is not bent and won't bend while in use.
And, yes, have seen many Garands with destroyed muzzles due to cleaning with the GI rods without a guide. Also saw quite a few lever actions with the same issue.
Sent from my SM-P580 using Tapatalk
Bookmarks