In a moment of weakness I ordered a Jard trigger and I have to say I'm glad I was weak. It was a very simple install in my Bat/s rifle. I did have to do some inletting with a die grinder but it was minimal. I requested a 16oz break and that is what I got. It had too much creep but setting the sear engagement was very simple as was the overtravel. The safety wouldn't work after these adjustments but I adjusted the safety screw out until it worked in all 3 positions. In my mind it's a much better mousetrap than the accutrigger. Gone is the stamped sear and exposed springs. I safety tested it by slamming the bolt over and over and by dropping it repeatedly from about a foot onto it's buttstock. It's a little overpriced but I like it so much I'm going to replace the red target trigger on my LRPV as well. It's going to take a little getting used to the light crisp break because right now it startles me at times when it goes off.