Reply With QuoteWell, start by reading this page.
http://www.6mmbr.com/gunweek093.html
7.5 twist, 28" barrel
Starting load for 75 gr vax's
SUGGESTIONS?
[B][SIZE=3]Dennis[/SIZE][/B]
Well, start by reading this page.
http://www.6mmbr.com/gunweek093.html
Very good article . . . .
[B][SIZE=3]Dennis[/SIZE][/B]
It dont cover the 75g v max, but It could give you an idea where to start.
Are we talking 6x47 LAPUA, or the original 6x47 derived from the 222 Rem mag case?
Makes a HUGE difference...
12F, McGowen 6.5x284 1-8" twist, Nightforce 12-42x BR<br />BVSS, McGowen barrel, 22-250 1-9" twist, Nikon 6-18x<br />16 FHLSS Weather Warrior, Sinarms 257 Roberts, Pentax 3-9<br />Stevens 200, 223 bone-factory-stock, Nikon 3-9x<br />Scratch-built BVSS, LW 243 1-8" twist, Viper 6.5-20x50 mil-dot
Slim, VERY GOOD POINT! 82boy knows I have a 6x47Lapua!Are we talking 6x47 LAPUA, or the original 6x47 derived from the 222 Rem mag case?
Makes a HUGE difference...
I was searching a few minutes ago and just found out there is a 222 Rem mag case neck up to a 6mm!!!!!!!! Refered to "6x47" Matter of fact it had a load suggestion for a 75 V-max only using 27.5grns of Varget! The COAL was way off! I started to write a comment and state someone made a mistake!!!!!!!! It made me do some digging but I found the information you stated above.
I just wish you would have commented earlier, it would have saved me a lot of time!!!!!!!!!
[B][SIZE=3]Dennis[/SIZE][/B]
Heck, I thought you knew of the old 6x47 rem based off of the 222 rem mag case. This was a short lived short range benchrest round in the mid 1970's to the 1980's. This is why when I mention it I always put a L or lapua after it to avoid confusion. This is also the reason why some call the round a 6-6.5x47.
I remember you saying this . . . . . NOW I realize why you said it!This is why when I mention it I always put a L or lapua after it to avoid confusion.
;D ;D ;D ;D ;D ;D ;D
[B][SIZE=3]Dennis[/SIZE][/B]
LOL,
Well the reason I asked was, (other than the obvious), I HAVE load data for the 75 Vmax, and the "old" 6x47 that is based on the 222 Rem mag case.
I still have and load for that "short lived" chambering.
;D
Fat lot of good that data will do you though, with that "new-fangled" Lapua magnum however.
12F, McGowen 6.5x284 1-8" twist, Nightforce 12-42x BR<br />BVSS, McGowen barrel, 22-250 1-9" twist, Nikon 6-18x<br />16 FHLSS Weather Warrior, Sinarms 257 Roberts, Pentax 3-9<br />Stevens 200, 223 bone-factory-stock, Nikon 3-9x<br />Scratch-built BVSS, LW 243 1-8" twist, Viper 6.5-20x50 mil-dot
Any load data for 75gr V-Max's for the 6.0x47 Lapua!
[B][SIZE=3]Dennis[/SIZE][/B]
Posting Permissions
Bookmarks