Not from trigger. Are you interested in selling red blade trigger ?
Just installed a Jard 7-12 oz trigger in my 12 Target 6mm Dasher, when I removed the original red blade trigger, I found a tiny ball bearing on the table and have no clue as to where it goes on the old trigger ? Bothered me enough that I went thru the Jard parts break down to make sure it wasn't from the new trigger.....(it wasn't) I have looked for a exploded view of the red blade trigger, is there one out there? Thanks for any and all help, rsbhunter
If you stand for nothing, Then you'll fall for anything!
Not from trigger. Are you interested in selling red blade trigger ?
Where you might find a small ball bearing on your Savage 110: Under the extractor on the bolthead(one of them). in the rear baffle of the bolt assembly(2 of them)
The Dunning-Kruger effect is alive and well.
I might sell the trigger after I find out if I like the Jard ..... I know its not the extractor ball as that's still together, and the shroud wasn't disassembled .....so I'll just keep guessing.... Everything works as it should, so its not a big deal...Thanks for the help....I thought it was a detent ball for the 3 position safety..but that works normal...rsbhunter@yahoo.com
If you stand for nothing, Then you'll fall for anything!
What is the diameter of the ball?
Bookmarks