110 scope mount

[250/3000]

I installed a Leopold variety all on a flat top receiver 110. I cannot get the scope sighted in. Ran out of adjustment 4 inches high at 100yds. What can I do to rectify this. Have medium height rings on it now. Lower ring height?

[Dave Hoback]

Scope height from the bore has no bearing on sighting I at 100yds. Are you certain you are adjusting the scope the correct way? 4” high at 100yds has you zeroed at like 400yds. If it truly is not adjusting to 100yds, there is something wrong with your scope.

[Blue Avenger]

did you by chance use a 20moa base?

[efm77]

The flat rear receivers were known to be warped quite often which can lead to problems like you're experiencing as well. It's one reason Burris Signature rings are so popular. If you're sure your scope is ok, you could try those.