I was reading in the FAQ section about tightening/torquing the AccuStock. The one in the FAQ section is in regards to the older 3 screw stock. Do those instructions still apply to the new AccuStock and do you tighten the screw closest to the end of the barrel first when you start torquing. Here is the instructions on the old stock........

2. With the action inserted into the stock, justify the action toward the rear of the stock to allow the recoil lug on the action to be seated against the boss on the aluminum rail.

3. Tighten the forward most screw to 10 in.-lbs. to seat the action against the aluminum rail boss, then back out one-half turn.

4. Tighten the middle action screw to 10 in.-lbs.

5. Tighten the rear action screw to 10 in.-lbs.

6. Tighten the forward action screw to 10 in.-lbs

Repeat steps four through six and increase torque value in increments up to a final torque value of 40 to 45 in.-lbs.