Hiya
all you need is a new barrel,barrel wrench,action clamp and headspace gauge.I made an action clamp from two pieces of bar stock and bored a 34mm hole through them.
MARK
I would like to look at making my 22-250 to a 308??? I have a Stevens 200 rifle, any input is appreciated.
Hiya
all you need is a new barrel,barrel wrench,action clamp and headspace gauge.I made an action clamp from two pieces of bar stock and bored a 34mm hole through them.
MARK
Thanks I am looking into those items now. Any suggestions for a barrel? Where to buy?
You can go use or new factory or aftermarket
give sinman or northland a call
go to the sponsors page
both are great to deal with
do not forget a new recoil lug
+1 on replacing the stamped factory recoil lug.
Vietnam Vet, Jun 66 - Dec 67
I have a heavy stainless 26-inch .308 barrel from a model 12 and I want to switch it out to an equivalent 22-250. The bolts will work on either.
yep
i was actually thinking of changing my 22-250 to a 308. i've been in contact with Sharp Shooter Supply and they said if i sent them my rifle they would replace the barrel with Douglas barrel, new bolt head and put everything on for $425.
All you need is a barrel and optional recoil lugOriginally Posted by 11fcns
so a new bolt head isn't necessary then?Originally Posted by sinman
A new bolt head is not necessary
Silence is golden.... duct tape is silver!!
Nope not needed
What about magazine differences?
The magazine is also the same
Silence is golden.... duct tape is silver!!
Do it. Don't hesitate. I have a 12BVSS that i waited and waited for until I found one in .308 and glad I did.
Bookmarks