Cleaned my Axis after a range trip yesterday. Have new springs on the FP. Had two failures to fire yesterday with CCI 200 primers. Tried twice and no go for each round. The dents did look pretty deep so I though maybe bad primers. Broke the bolt down today just to be sure nothing was wrong with the springs or FP. Measured the firing pin protrusion and it's at .051". Reassembled the bolt and slid it back into the action, closed the bolt and that's when I noticed the FP slide forward as the bolt closed. I triple checked everything and can't see why the FP won't stay cocked. Removing the action from the stock I noticed the sear will no longer slip into the trigger groove. Sear and trigger just sit there when I close the bolt. I can't induce the sear to stay in the trigger notch. The sear and trigger looks ok to me so I'm really stumped at this point?