Which 6mm chambering?

[mikeinco]

that is what happens when i do a cut and paste, code for the pic, no pic

[mikeinco]

look at the very end..it says IMG(AGE).

the boss should delete the post..waste of bandwidth

[charlie b]

Out of the cartridges you listed....I’d run the 6BR. Barrel life will be so much better than the .243win., 6mm Rem, 6CM etc...I’ve shot them all. Also vs. the 6 Dasher you don’t have to form cases at all. To me the Dasher can be temperamental with that really short neck but it is a shooter. The 6PPC would most likely need a different bolt head. The rim diameter is smaller than the others. It might not but I think it would make life easier.

I’m shooting a 6BRA right now on a rebarreled Savage 112 J series single shot. 107smk are coming out just under 2900fps and that’s out of a 26” barrel. You just shoot normal 6BR loads thru it and no difference in accuracy vs. the formed 6BRA case.

Later, Frank
Bartlein Barrels

So why did you choose the BRA variant of the BR? Since you mentioned the short neck in the Dasher I would assume that to be the reason? I was browsing over the 1000 and 600 bench rest results boards from this year and did not see a huge trend in one over the other.

If going to 1000yd would you use the 6mm or go up to something else? Last (maybe ), is the barrel life the same with all the 6BR variants?

[Robinhood]

6-6.5x47
243
6 Creedmoor