Results 1 to 3 of 3

Thread: 110c mag release button

  1. #1
    New Member
    Join Date
    Nov 2019
    Location
    minnesota
    Posts
    6

    110c mag release button


    Hello, I purchased a 110c j series short action .243. It is missing the side mount mag release button and escutcheon. Was hoping to get some precise measurements and pics for an attempt to have them 3D printed or maybe someone has a replacement idea for me.
    Thanks

  2. #2
    Basic Member
    Join Date
    Dec 2018
    Posts
    155
    They are easy to make. I’ve made a couple to replace the factory ones out of stainless steel barrel stock. I made the release button a little longer so I can release the mag easier with a gloved hand. For the escutcheon I glass bedded it into the stock.

    Stock release button measures .257” oal, the side that pushes against the mag housing lever measures .370” o.d. And the lip is approx. .030” thick. The flat side has a slight crown to it. The diameter of the button that goes thru the escutcheon is .312” and the length of that to the shoulder is .204”

    The escutcheon has a thru hole of .315”. The part that of it that sits in the stock is .564” in diameter with a shoulder length of .145”. The outside lip that you see from the stock side is .674” in diameter. The cup/radius in of it is approx, .100” deep. For the radius I used a ball nose end mill but off hand I don’t remember the diameter. I could look at work tomorrow for ya.

    I cannot post pics but if you give me your email address I can send you a sketch if it helps.

    I have a spare set if you want it. The escutcheon is kinda beat up (there just plastic) but you could use it for a pattern.

    Later, Frank
    Bartlein Barrels

  3. #3
    New Member
    Join Date
    Nov 2019
    Location
    minnesota
    Posts
    6
    Thanks Frank, very helpful.

    Mark

Similar Threads

  1. Escutcheon and mag release button
    By Patrizzo in forum 110-Series Rifles
    Replies: 0
    Last Post: 06-01-2019, 09:11 PM
  2. Replies: 8
    Last Post: 08-04-2018, 09:56 PM
  3. Help! Bolt release button is stuck
    By uncle-buck in forum 110-Series Rifles
    Replies: 9
    Last Post: 11-15-2017, 05:36 PM
  4. Replies: 4
    Last Post: 11-04-2016, 12:23 AM
  5. 111 magazines with side release button in 30-06
    By cnwwyo in forum 110-Series Rifles
    Replies: 1
    Last Post: 06-16-2013, 02:42 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •