Geez haven't been to this forum in many years, think the Axis was brand new last time I was here.
Anyway; deer on ground, went to cycle remaining rounds out of magazine, must have had one not quite sized right and jammed the bolt. OK. Took it back to the farm, tapped it with a rubber mallet and broke it free. The above mentioned trigger is set to 2#, to match a .223 used in the summer. Trigger pull still feels about the same, but now safety lets trigger go in both safe positions. The move bolt position breaks with little pressure on trigger, the bolt lock position you have to pull pretty hard but will still break. Pretty sure I know what needs fixing, but would like the group's 2 cents to see if I'm on the right track.
Ideas please.
Thanks