Tried to do a angled bolt handle. Where the angle was made into the base of the handle, it looks nasty in the handle slot. Can't change it now.
The handle is not as big as it looks in the picture. But it is a little too long.
Tried to do a angled bolt handle. Where the angle was made into the base of the handle, it looks nasty in the handle slot. Can't change it now.
The handle is not as big as it looks in the picture. But it is a little too long.
The Dunning-Kruger effect is alive and well.
I dont think it looks bad.. does it function properly?Originally Posted by Robinhood
Tried to do a angled bolt handle. Where the angle was made into the base of the handle, it looks nasty in the handle slot. Can't change it now.
The handle is not as big as it looks in the picture. But it is a little too long.
Sent from my SM-N975U using Tapatalk
It still fits in the channel
You could open it up a bit to even things out but then you would have to match the stock finish which could be interesting.
Does not look bad at all! Did you make that yourself?
I did.
The Dunning-Kruger effect is alive and well.
Time to break out the die grinder and the bondo! Open the rear of the slot up for clearance, then use the bondo to fill in a little of the front side of the slot so the gap is evened out. Lightly scuff the rest of the stock with 400-grit, spray on a fresh coat of Krylon Fusion and call it good.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
"Like button"Tried to do a angled bolt handle. Where the angle was made into the base of the handle, it looks nasty in the handle slot. Can't change it now.
The handle is not as big as it looks in the picture. But it is a little too long.
I like it too, nice work!!
Posting Permissions
Reply With Quote
Bookmarks