I have a Mark II and when I quickly close the bolt the inner portion of the trigger locks up and will not allow the trigger to be pulled until the bolt is lifted up and then placed back down again slowly. If the bolt cycling is done quickly again the same issue happens again. I took the action out of the stock and can see what is happening thru the hole in the side of the trigger. When the bolt comes down fast it causes the sear? to go past where it is normally stopped till the inside portion of the trigger is pulled. When it goes past where it is supposed to stop it blocks the path where the inner portion of the trigger is supposed to pass. I do not see anywhere where an adjustment can be made to fix this. Is there a fix for this issue? This gun has only fired a box or two of ammo so it is nearly new, puzzled why it has the issue, a design flaw? Anyone seen this before?
Thanks!!