Results 1 to 7 of 7

Thread: CIP length bottom metal and inletting for it

  1. #1
    Basic Member
    Join Date
    Nov 2013
    Posts
    28

    CIP length bottom metal and inletting for it


    I am starting a 300 PRC build with a old flat back 7 mag action and will need a new stock and Bottom metal that will accommodate the long round.
    I had it all figured out but sadly Mr Allen from CDI Gunworks has past and now I am starting over.
    Any and all ideas or comments are welcome

  2. #2
    Administrator J.Baker's Avatar
    Join Date
    Dec 2006
    Location
    NW Ohio
    Age
    49
    Posts
    6,409
    Passed as in passed away, or passed as in didn't want to do it?
    "Life' is tough. It's even tougher if you're stupid." ~ John Wayne
    “Under certain circumstances, 
urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain

  3. #3
    Basic Member
    Join Date
    Nov 2013
    Posts
    28
    Passed as in passed away

  4. #4
    New Member
    Join Date
    Nov 2016
    Posts
    8
    I am in the same boat.CDI was going to inlet my new 300 win mag with there metal and aic mag set up.I have looked around and have not found any body who does savage rifles Post it up here if you locate some one please.

  5. #5
    Basic Member
    Join Date
    Nov 2013
    Posts
    28
    I have a local Smith who has told me he could do it. I bought a Choate tactical stock and a spare center section for him to practice on. I also have a Savage 338 Lapua stock that he can measure and use as a guide. I haven't had it done yet so cannot tell you how it looks .

  6. #6
    Basic Member
    Join Date
    Dec 2012
    Posts
    83
    Sorry to bump a older thread but was cdi a one man shop? So they no longer do it? Can you still buy the cdi products?

  7. #7
    Basic Member
    Join Date
    Nov 2013
    Posts
    28
    My understanding was that it was a one man show. I have not tried to contact them since I was told he had passed

Similar Threads

  1. Accustock inletting vs regular bottom metal inletting?
    By Thunger in forum 110-Series Rifles
    Replies: 4
    Last Post: 11-30-2016, 06:01 PM
  2. inletting for bottom bolt release
    By emmagator in forum 110-Series Rifles
    Replies: 2
    Last Post: 12-06-2014, 01:51 PM
  3. Replies: 0
    Last Post: 07-10-2014, 12:31 PM
  4. Inletting B&C stock for new bottom metal?
    By tacticalpanda in forum 110-Series Rifles
    Replies: 11
    Last Post: 05-17-2013, 03:56 PM
  5. Inletting for Detachable Bottom Metal
    By Solothurn in forum 110-Series Rifles
    Replies: 2
    Last Post: 03-19-2010, 05:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •