With the stock off, I can adjust the accu trigger to the lightest setting, run the bolt and bang the barreled action around without a problem. When I install the action back in the stock and snug the action screws, I can run the bolt and bang the rifle around without problems. When I torque the action screws, and pull the trigger the sear won't reset.


If I put a couple of turns into the accu trigger trigger spring or don't torque the action screws, all is okay.

I have had Savage rifles that won't hold the sear on with the accu trigger set too light but it did it with the action out of the stock.

I can't seem to see what is causing the problem.

any help would be appreciated