It’s a 6.5CM, 140gr Hor BTHP w/41.5 grains 4350, Hor 2xfired brass.
Have shot over 200 of this load fine.
Today at range fired a shot, went to load another round and bolt was jammed.
Bolt would lift, but not travel to rear to eject case.
Did the stock bump on the bench seat and bolt went full back and kicked case out.
However, now can not get bolt out of action. Can run bolt back in and close, but trigger not cocked.
Saw that firing pin was distorted. See pic.
Plan on taking action/barrel out of chassis to inspect.
Is it possible to disassemble bolt in action to free it up and remove from action.
Thanks, Red
Reply With Quote
Bookmarks