New Shilen Match Select .223 Rem Build

[Bill2905]

I completed my first new barrel install last week and took it out to the range yesterday.

Savage 12FV
(NSS) Shilen Match Select / .223 Rem / 26” Varmint Contour / 1:9 Twist
NSS Recoil Lug and Nut
NSS Action Wrench and Nut Wrench
(NSS) Manson Headspace Gauges
Bell & Carlson Medalist
Vortex Golden Eagle HD 15-60x52
Warne 0 MOA Rail / Fixed Medium Rings

I did an abbreviated break-in by brushing/patching/oiling the barrel after each of the first five shots and then using Sweat’s 7.62 on a patch after five shots. There was some blue contaminant present but the patches came clean after five of them. I then brushed/patched/oiled the bore after 10 rounds and 15 rounds. It was 34 degrees and breezy so I called it quits on the break-in.

I shot five groups (25 rounds) of Hornady 55gr V-Max factory loads before the cold and setting sun sent me packing. My bench shooting skills are not that good and I suffered from the usual flyers. But overall, I was pleased with the barrel as I was able to put multiple rounds into the same hole on several groups before pulling a few.

I was amazed at how easy it was to clean the barrel afterwards, ending up with just faint gray on the patches in a relatively short time. I followed up with another Sweat’s 7.62 treatment and was pleased to see zero evidence of copper on the patches. A far different experience than cleaning my factory barrels.

Many thanks to James at NSS for steering me in the right direction and providing excellent customer service.

[Ted_Feasel]

I completed my first new barrel install last week and took it out to the range yesterday.

Savage 12FV
(NSS) Shilen Match Select / .223 Rem / 26” Varmint Contour / 1:9 Twist
NSS Recoil Lug and Nut
NSS Action Wrench and Nut Wrench
(NSS) Manson Headspace Gauges
Bell & Carlson Medalist
Vortex Golden Eagle HD 15-60x52
Warne 0 MOA Rail / Fixed Medium Rings

I did an abbreviated break-in by brushing/patching/oiling the barrel after each of the first five shots and then using Sweat’s 7.62 on a patch after five shots. There was some blue contaminant present but the patches came clean after five of them. I then brushed/patched/oiled the bore after 10 rounds and 15 rounds. It was 34 degrees and breezy so I called it quits on the break-in.

I shot five groups (25 rounds) of Hornady 55gr V-Max factory loads before the cold and setting sun sent me packing. My bench shooting skills are not that good and I suffered from the usual flyers. But overall, I was pleased with the barrel as I was able to put multiple rounds into the same hole on several groups before pulling a few.

I was amazed at how easy it was to clean the barrel afterwards, ending up with just faint gray on the patches in a relatively short time. I followed up with another Sweat’s 7.62 treatment and was pleased to see zero evidence of copper on the patches. A far different experience than cleaning my factory barrels.

Many thanks to James at NSS for steering me in the right direction and providing excellent customer service.

Isnt it nice how easy they clean up? Not to mention the ungodly accuracy

Sent from my SM-N975U using Tapatalk