Nice work. Could have also ordered one from DIP.
https://www.diproductsinc.com/Products.aspx?CAT=3602
A quick post of a stock and bottom metal upgrade for my MkII Heavy Barrel.
I swapped my polymer stock for a laminate, but the bottom metal needed some serious help. My goal was to have bottom metal properly anchor the stock, as with this model, there is not a lot of laminate stock between the receiver bosses and the metal.
Heavy barrel - seems to call for heavy bottom metal. I got some bottom metal made from 1/8" Stainless Steel. I eventually located the required length 12-32 (unobtanium) button head screws. Still need to seal the wood and add short pillars prior to hitting the range.
The pics can tell the full story...
Stamped 1/8" stainless steel
~3mm = 1/8"
Milled out the stock for the metal
No metal protrudes past of the laminate
Snugged in the screws
Stainless Bottom metal installed
Footnote - this is a heavy barrel, I opened up the barrel channel with a deep socket wrapped in sandpaper... very free floating now.
Nice work. Could have also ordered one from DIP.
https://www.diproductsinc.com/Products.aspx?CAT=3602
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
Bookmarks