Results 1 to 5 of 5

Thread: Bedding a det/mag stock

  1. #1
    Basic Member
    Join Date
    Aug 2007
    Location
    Brushy Mtns, NC
    Posts
    615

    Bedding a det/mag stock


    Anyone offer suggestions, am prepped to bed this det/mag stock. Should the mag well be completely filled with modeling clay, or just make a lip below the action cut out and grease the well and action with release?

  2. #2
    Elkbane
    Guest

    Re: Bedding a det/mag stock

    I did not put anything at all in mine; but I used Devcon Steel, which has the consistency of peanut butter and doesn't flow much. I just trimmed off the little that went into the mag well with a dremmel tool after I was done. Unless you're using a bedding compound that's really viscous, I can't see where you'd need to fill the mag well.

    Elkbane

  3. #3
    Basic Member
    Join Date
    Aug 2007
    Location
    Brushy Mtns, NC
    Posts
    615

    Re: Bedding a det/mag stock

    Yeah, that would be better material than the devcon I just used. It was too thin and set quickly. It did a good job however, would look nicer with a skim coat of the devcon steel. I filled the well with clay, made a lip, and was able to bed the narrow top portions as well. I drilled all surfaces for bonding. Being it is a cheapo synthetic stock, it may not hold the small narrow top-side around the well.

  4. #4
    Basic Member
    Join Date
    Aug 2007
    Location
    Brushy Mtns, NC
    Posts
    615

    Re: Bedding a det/mag stock

    The action popped away from the stock fine, the molding clay was a pain to clean however. The action fits very snugly with the bedding holding along the top of the well sides. I may remove it later if there is sign of binding. I went back and relieved the material from under the barrel nut.

    I used a member's photos to help me on the bedding job, his board name is lion. If anyone needs simple step by step photos, get them in his post in the picture post topics.

  5. #5
    Lion
    Guest

    Re: Bedding a det/mag stock

    Hi there!
    I´m pleased that you found the pictures helpful.
    So long, Lion

Similar Threads

  1. bedding/pillar bedding a boyds stock
    By blink in forum 110-Series Rifles
    Replies: 12
    Last Post: 10-01-2015, 12:17 PM
  2. Replies: 0
    Last Post: 09-15-2014, 11:28 AM
  3. Bedding a HS stock
    By KTP in forum 110-Series Rifles
    Replies: 6
    Last Post: 12-03-2013, 11:03 AM
  4. Stock bedding how-to?
    By MikeInSC in forum 110-Series Rifles
    Replies: 18
    Last Post: 03-02-2013, 01:18 AM
  5. bedding a Savage 12 f t/r with stock stock
    By Grand Poo Bah in forum 110-Series Rifles
    Replies: 1
    Last Post: 12-08-2011, 06:55 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •