Ok, so I'm wondering if this is common or not and if there's any need to correct this .

Have a left handed short action receiver.
I can turn the bolt till the bolt handle touches the rear slot in the receiver at the tang. Stock bolt handle. Looks like the design is such that the bolt turns until the bolt handle contacts the bottom of the cut out in the tang, is that correct?

Now, I removed the barrel for a re barrel, and when I close the bolt and look down the receiver at the bolt face I noticed the lugs actually travel further than 90 degrees before coming to a hard stop, if that makes sense.

This bolt travels about 95 degrees instead of 90 before the bolt handle comes to a stop at that milled out spot on the tang.

From what I can see this should not be an issue, but perhaps I'm overlooking something :) Curious...