Hello all you LRH 111 folks. My first post after much time digesting all of the posted wisdom here. Has anybody ever done this? Remove and replace the Accustock on a 300 WinMag 111 LRH hinged floorplate, bottom bolt release for a Boyd's "at one" stock which is only offered for the LA, bottom bolt release, DBM? I am fully prepared to purchase and install the DBM "kit" from Savage to make the receiver/barrel compatible with Boyd's offered product. I have a question going to Savage at the moment, and have not gotten an answer yet about "built as a DBM" model measurements vs "converted to DBM" model measurements. I have this gut feeling that some of you have already "blazed the trail" in this regard. Thanks in advance for your generous advice.