Anyone put a suppressor on a stock 10FCP-K barrel

**DreamMaker** · 10-07-2010, 02:52 PM

My SAS Arbiter suppressor was finally approved. I searched the forum to see if anyone has removed the factory brake and threaded a suppressor onto the barrel - nothing came up. Anyone done it? Any problems getting the brake off?

Thanks

sinman · 10-07-2010, 06:57 PM

I have, your threads are going to be different, Just cut off and rethread.

kenbo776 · 10-09-2010, 05:10 PM

ummmmm... DreamMaker wish we could have fun toys like suppresors in my state. That would make my dream.....

eight_heads · 10-12-2010, 04:57 PM

threads are 5/8"-24 same as an AR-10

LawmanSales · 10-14-2010, 09:44 PM

I have seen both 9/16"-24 and 5/8"-24 stated in reviews. Has anyone actually measured themself?

Corsica Coatings · 10-14-2010, 11:18 PM

.308 should be 5/8 x 24 TPI
.264/6.5mm should be 9/16 x 24 TPI

You may see them threaded differently, but those are the industry standard.

eight_heads · 10-15-2010, 01:57 PM

Originally Posted by Brazos609

I have seen both 9/16"-24 and 5/8"-24 stated in reviews. Has anyone actually measured themself?

I had an ar10 thread protector on my flcp-k for a whille that was 5/8-24

**DreamMaker** · 10-21-2010, 01:21 AM

Boy that was easy! Made myself some barrel blocks out of 1 1/2" oak I had lying around. Put the barrel in a vise and got everything snugged up. Put some Kroil around the base of the brake and crush washer. After having a light lunch, I decided to put a wrench on it and give it a twist... came right off!

It's 5/8 x 24 TPI and the SAS brake threaded right on with no problems. FWIW - if your suppressor threads onto a FA/brake, you'll need to use Loctite on the FA/brake. Ask me how I know