I am installing a DNZ scope mount on a Savage Axis. With the front mount screws tightened down I can slide a sheet of common notebook paper under the mount but with friction, same goes for the front when the back screws are tightened however the tension is much tighter, almost ripping the paper. I cannot see any light under either contact point and can't hear any click from the mount hitting the receiver when tapping on the top of the mount. Should I bother bedding the mount or not? When you torque your screws, what in/lb do you torque to? 25 in/lb seems to be most common. And finally, should I bother with blue Loctite for the screws? if so will 25 in/lb be too much torque due to the lubricating effect of the loctite?