I am just getting started on a 338-06 build. One of the reasons that I went this way is my over abundance of 30-06 brass. I am still a ways away from reloading but I am pondering the steps I need to make for this process. I plan to sort the brass by make, then go through it to inspect it-mainly looking for case wear etc. as there is some that I know have been reloaded more than once. I then plan to resize, inspect and place into cartridge boxes marked accordingly for the 338-06. Is there something I am missing or something else to consider? I was wondering if I should mark the brass somehow? Anyone have suggestions on the best brass for necking up to the 338?
I plan to post a separate thread on reload recipes after I review some more here and other places online.
Thanks in advance