Since it's firing I would take that to indicate the main spring is good. The trigger not returning forward would likely be the trigger spring.
Just bought a 24S-E where after I fire it I have to manually push the trigger forward because otherwise the barrel(s) will not close after “broken” open nor will the hammer lock to the rear. Almost seems like a spring is missing or broken.
Otherwise the gun functions normally. Any ideas?
I thank you for any input.
BJ
Since it's firing I would take that to indicate the main spring is good. The trigger not returning forward would likely be the trigger spring.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
Thank you Mr Baker! It looks like all I have to do is to the stock off to have a look at the mechanism. It should be easy enough to see what’s missing/wrong. A cursory web search shows that parts shouldn’t be too difficult to get.
Thanks again, BJ
Just be forewarned that the main spring in these guns is HEAVY. It's been a few years since I've owned one, but if memory serves me right there was a YouTube video that showed a makeshift tool to help compress the main spring for disassembly.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
OK, we’ll proceed with caution.
Thanks again, BJ
Upon closer inspection, nothing was wrong. Somebody got carried away with spray can blueing and gunked up the trigger mechanism. I cleaned things up and the gun operates like it should. Question regarding the firing pin screws (#29 & 30 above): both are present and threaded in the receiver so they don’t protrude. They are not tightened however and I wonder how they are supposed to be installed properly? My model is a 24S-E which is different but I assume these screws have the same function on mine?
Any suggestions are appreciated!
BJ
The screws going into the side of the reciever? I would imagine those should be snug, but don't go all Magilla gorilla on them.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
One of the screws snugs up, the other one doesn’t, seems I could tighten it until it disappears in the receiver. I’ll leave well enough alone since the gun works fine.
Thanks again!
Bookmarks