Looking at their site shows the extractor mod similar to what I have had success with.
With the extractor firmly held I use a three corner thread file to file back the area under the extractor lip
This mod allows the extractor to slide on to the rim a few thousandth more.
Then I use a dremmel with a small "carrot" shaped stone to relocate the center point of the ball socket. Again .005 or .010 is about the max you are able to achieve.
This mod has worked miracles on the only two actions I have tried it on (both 6.5 Creeds).
They no longer "drop" or "flip" cases in the mag. So far after about 50 ends each....no drops...yeh.
I would bet the Kinney kit might work. It also looks like the ejector has an angle cut on the end. Might be worth some more experimentation.
My .02,
Randy
Bookmarks