So I managed to find myself a couple of new bolt heads for my rifle so i can switch it out to all calibers!!

The ones I recieved however, are older ones with the large firing pin hole through the bolt head. Savage changed the diameter of the firing pins a few years back from .145" to .095". The reason they did this was to have more strength in the bolthead retaining pin by keeping the hole smaller.

I am wondering, would I have any issues using my 0.095" firing pin and bolthead retaining pin with a bolt head with a 0.145" firing pin channel?

I am thinking that the firing pin will be held in good alignment by the cross pin, and the smaller hole in the bolt face where the pin ultimately protrudes(they are the same diameter where they protrude from the bolt face)

Does anyone have any thoughts on this, or have you done it before?