I had to return my new scope to the manufacturer because I was getting weird POI shifts trying to sight in my new Model 10 Predator. I was sent a replacement and I want to be 'just right' as I remount the rings and scope. I watched a Leupold video about scope mounting and they did not seem to apply much pressure at all while tightening down the rings. I tend to be very uniform as I apply a little more pressure to each screw and keep going screw to screw to keep the gap even, but suspect I end up applying more pressure than they did in the Leupold video. I tend to do it very tight using just my finger-tips.

Is there a torque spec I should aim for? I am going to get a in-lb torque wrench anyway since I'll need one for the Accustock.