Greetings,

I just purchased a new Savage MSR 10 Long Range in 6.5 Creedmoor.

In the first 6 rounds fired, 3 of the shells would not eject from the chamber, and had to be tapped out through the bore using a cleaning rod.

I thought that perhaps the gas pressure was set too low, so I increased it by three clicks. Now the ejector break off a section of the cartridge rim, indicating that the pressure should be turned back down.

In all cases (excuse the pun), the cartridge case remains in the chamber. It is almost like the chamber is a tad too narrow for the cartridge.

BTW, I am shooting 140 grain Seller & Bellot tactical ammuntion. And yes, I did clean the rifle before my first shot.

Have any of you MSR 10 users run into this?

Any ideas would really be appreciated!!

Thanks

SteveLorb