New msr 10 308. Guess I'll be lapping the barrel
New msr 10 308. Guess I'll be lapping the barrel
Ribbed for your bullets pleasure.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
That's why my LRP no longer wears the factory barrel. Looked like that too!
"An armed society is a polite society"
"...shall not be infringed" What's the confusion?
How does it shoot?
Good now. Shooting a 2.5" at it's best before lapping. Running 50.50gr of cfe 223 with a 130 ttsx with hbn2. Getting 2859 fps and 3/4 moa 5 shot groups consistently. 51.3 ran 2910 and was about 0.800" at 100, but it's getting close to the top. Should be hunting pigs next month I hope.
I would have sent it back. That's some pretty crappy barrel work. That Tubbs Final finish is good stuff though.
I liked most of the gun. I figured that of the barrel was bad, I could get a match barrel and still be cheaper than most all the high end ar 10s. Getting it to shoot without changing barrels is a bonus. Changed the trigger, grip, and added a suppressor. Topped it off with a Trijicon reap ir and I ready to go.
What trigger did you install?
Update.
I been running the gun with 125 Nosler BT for deer.
130 TTX for hogs. I also started shooting Hornady 150 spbt for hogs. The guns got about 18 hogs on it., about 15 coyotes, and a bunch of deer off of permits. The 130s and 125s are by far the most accurate out of the gun. I'm now running an H2 buffer. It is a bit picky, but it has a sweet spot where it runs like a champ.
Bookmarks