Savage 110 Recoil Pad

[idunham]

I had looked through the forum for an answer, couldn't find one - neccesarily.

Savage 110, stock off of numerich that I finished.

I had purchased a Limbsaver 10601, and it did not fit the stock, at all. The screw holes were close to lining up, but it didn't go clear to the top of the stock, and it overhung at the bottom. (Wouldn't fit if i flipped it over, either. )

I have a hard plastic butt pad - I pulled up the recoild pad template, and i could not find anything that would fit/line up with the screws.

I'm shooting a 7mm-mag, and don't really want hard plastic up against my shoulder.

Anyone have any idea of another model number from limbsaver? Or, a recommended recoil pad that is squish like the limbsaver?

[Zero333]

Look into a Limbsaver "Grind to fit".

They're specifically made to be ground to fit unlike a standard limbsaver pad is not.

[idunham]

Which one? I can't remember, but i didn't think the screw holes lined up.

[Duckbill]

I’ve got a thread going similar to this. Screw holes are 3-1/2” apart and the only pads I can find are 3-1/8” apart