Reply With QuoteA properly sized cartridge, or a go gauge, should protrude approximately .125” from the chamber. Any less than that and you run the risk of breechface/bolt head contact as you’ve already seen.
I know. I know. But the machined surfaces on the PTG Bolt Head look so good. The firing pin fit perfectly as far as diameter but had to adjust the protrusion. Set it at .038. Then had to adjust the depth of the cocking piece. Then if that wasn't enough, bolt head hit the back of the barrel before the headspace got set. So I turned about .010 off the breech face and now it works. Case doesn't project out to the extractor groove on the case so it should be good? Still have a little more than an eighth of a turn of the action before the bolt head hits after the go gauge bottoms out. Everything works and fits well. Is that enough gap between bolt and breech face?. I also ordered a new extractor and ejector, springs and pin. What say ye?
A properly sized cartridge, or a go gauge, should protrude approximately .125” from the chamber. Any less than that and you run the risk of breechface/bolt head contact as you’ve already seen.
Originally Posted by keeki
Guess it doesn't really matter. If ya cant afford $15, you won't be buying much anyways
The rifle came headspace .002 more than my Go gauge. I've got 8 to 10 thousandths between the bolt and barrel now. With the deeper bolt head, I don't know if I could have taken as much off of it as I did the barrel. Haven't shot it yet but it chambers fine.
Bolt face depth is .130.
Lets see, case protrusion .125. Bolt face depth .130? Hmmmm
I had the same issue recently with a PTG bolt head I bought from Bullets.com. I would have returned it but needed to get this build off my bench. I did the same as the OP. Took some metal off and I was good to go. The three I have ordered previously fit with no issues. I was very surprised that this problem existed. PTG bolt heads have been top notch...I wouldn’t hesitate to buy another. Actually been thininking about ordering one without the ejector..
I got mine from Grizzly at a good price and it is a work of art. Very precisely machined but the dimensions were wrong. I was really glad the firing pin diameter was correct. I'm still waiting on the ejector, spring, and pin. Anyone noticed how slow Midway has gotten on getting their orders shipped ? This is the third one that has taken nearly a week to be shipped. All in stock.
Well I fired it today. Just checking primer strike. works fine. Also got the ejector installed. GTG
Posting Permissions
The sole purpose of this site is to provide an online community for those who wish to interact with other Savage firearm enthusiasts.
The information and opinions expressed within this site are those of its contributors, and in no way should be viewed as the opinions or recommendations of Savage Arms.
This site utilizes affiliate programs to generate revenue and as such purchasing a product reached by clicking on a link on this site may earn us a small commission on that sale.
Bookmarks