Reply With QuoteSounds like Savage got a bad batch of bottom plates or housings from a supplier. Personally I would probably just glue it on and be done with it as the only other option is to keep contacting Savage until you get a good one.
Has anyone had any trouble with the bottom of there Savage Model 25's magazine falling off. When loading it with four rounds the bottom of the mag falls off spilling ammo and spring on the ground. It seems like this magazine can't take the pressure of four rounds this magazine should have never been made of a composite material. I contacted Savage and they sent me a new magazine but it does the same thing.
Sounds like Savage got a bad batch of bottom plates or housings from a supplier. Personally I would probably just glue it on and be done with it as the only other option is to keep contacting Savage until you get a good one.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
Welcome aboard...
Perpetual Optimism is a force Multiplier....
Had 7 mags and had the same problem with some of them. Sent them back to Savage and they replaced all of them and sent the orginals back too. Out of them all I now have quite a few that work fine. I just don't take the questionable mags to the range. I also printed an extender that replaces the bottom and adds another round to the mag. It presses in tight to the bottom of the mag. It sure would be nice to have a metal mag.
Posting Permissions
Bookmarks