I'm getting some serious copper fouling in my 270 WSM.

http://www.savageshooters.com/showth...WSM-build-woes

Going to run the Tubbs Final Finish bullets through it. I emailed Tubbs and they recommend using the starting loads from the Sierra manual for a 130 grain bullet. They also said that Varget and H4350 are recommended powders. But in today's litigious society, they would not give me any specific charges.

They also said that these bullets should run about 2200 to 2500 fps, but that I probably would not find any loads that slow in a 270 WSM. I will probably have to load them to about 2800 fps.

I have a Hornady, Nosler and Lee manuals. The Hornady manual shows loads down to 2800, but not with these powders. The Nosler and Lee manuals only show loads down to about 3000.


If you have the Sierra manual, could you give me the starting loads for a 130 grain bullet in a 270 WSM using Varget and H4350, with the listed velocity?

Thanks in advance.